Affiliate Disclosure: This post contains Amazon affiliate links. If you purchase through these links, eBlogarithm may earn a commission at no extra cost to you. Prices and availability are subject to change.
Affiliate Disclosure: eBlogarithm is reader-supported. When you buy through links on our site, we may earn an affiliate commission as an Amazon Associate at no extra cost to you.
Troubleshooting: Clearing Roborock Q5+ Jams & Error Alerts
If your Roborock app sends an “Error 5” or “Main Brush Jammed” notification, follow these simple fixes.
Quick Troubleshooting Fixes:
- Remove Main Brush Cover: Squeeze the two red tabs to pop off the main brush guard.
- Pop Out Axle Bearings: Pull the rubber brush out and slide the removable side caps off to clear hair wrapped around the inner metal pins.
- Clean Cliff Sensors: Wipe the 4 bottom cliff sensors with a dry cloth to clear “Error 4 (Dirty Sensors)” warnings.
🤖 Further Reading: Read our comprehensive Roborock Q5+ Robot Vacuum Review — 2700Pa suction benchmarks, Auto-Empty Dock Pure 7-week test, LiDAR 3D mapping guide, pet hair rubber brush performance, and Roomba comparisons.
